846-GP 12/05846-GPNeo-Angle EnclosureTechnical Assistance is available Monday - Friday 8:00 a.m. - 5:00 p.m. (Central Time)1-877-723-7190
846-GP 12/05On opening side of door, caulkjoint where magnetic door stopand sill meet.On opposite side, caulk wherehinge door stop and sill meet.OUTS
846-GP 12/05Before starting installation of your new enclosure, carefully read all instructions and lay outparts to become familiar with their identi
846-GP 12/058A x 1 Pan Head Screw(H479 - Used for Jambs)OUTSIDE OF SHOWERBA942JAMBA710DRIPRAILH470TRUSS HEAD SCREW8A x 1 1/4 Flat Head Screw(H810
846-GP 12/05There are three parts that make upthe sill (A) -- a door sill with twomitered (pointed) ends, and two wingsills, each with one mitered en
846-GP 12/05File to fitcontour of yourunit.Mark throughholes in sill anddrill.If anchors (N) are used, holes should bedrilled using 3/16" drill
846-GP 12/05Adjust side panels, corner posts, and doorstops until magnetic strip aligns properly ondoor panel and door closes evenly at topand bottom
846-GP 12/058A x 3/8" TrussHead ScrewsMetalGussetJoin the three header parts together atmitered ends using metal gussets (Q).Make certain that e
846-GP 12/05Position header over unit and lower into place.Join header to jambs by drilling, from insideshower, through long leg of header into jambs
846-GP 12/05EDrip RailSmoothDrip Rail Sweep(Trim vinyl even withdrip rail if needed.)FINSIDE OF SHOWERDoor PanelMeasure width atbottom of door oninsi
Kommentare zu diesen Handbüchern